buffers, delay and volume control
Posted: Tue Nov 05, 2013 2:21 pm
I have a few questions:
First, I am using three monitors with the two outside screens with speakers built in. These are hooked up by audio cable w/splitter to my R/L audio jack. I am also using a USB speaker system. I am currently using "listen to this device" to the monitor speakers. I'm experiencing some lag. The FAQ says that's the trail version.
I was wondering if you guys have the best way to make this work?
Also what settings for Buffers, Sample Rate, Bits per sample, channel I should be using?
Also I noticed that if I just select my real microphone and my real audio card and just start the "Output" side it still works? Then what's the point of the left side?
Sorry if this is hard to understand!
First, I am using three monitors with the two outside screens with speakers built in. These are hooked up by audio cable w/splitter to my R/L audio jack. I am also using a USB speaker system. I am currently using "listen to this device" to the monitor speakers. I'm experiencing some lag. The FAQ says that's the trail version.
I was wondering if you guys have the best way to make this work?
Also what settings for Buffers, Sample Rate, Bits per sample, channel I should be using?
Also I noticed that if I just select my real microphone and my real audio card and just start the "Output" side it still works? Then what's the point of the left side?
Sorry if this is hard to understand!